EN25Q32B
EN25Q32B
32 Megabit Serial Flash Memory with 4Kbyte Uniform Sector
FEATURES
• Software and Hardware Write Protection:
- Write Protect all or portion of memory via
software
- Enable/Disable protection with WP# pin
• Single power supply operation
- Full voltage range: 2.7-3.6 volt
• Serial Interface Architecture
- SPI Compatible: Mode 0 and Mode 3
•
-
• 32 M-bit Serial Flash
- 32 M-bit/4096 K-byte/16384 pages
- 256 bytes per programmable page
•
-
Standard, Dual or Quad SPI
Standard SPI: CLK, CS#, DI, DO, WP#
Dual SPI: CLK, CS#, DQ0, DQ1, WP#
Quad SPI: CLK, CS#, DQ0, DQ1, DQ2, DQ3
•
-
High performance
104MHz clock rate for one data bit
80MHz clock rate for two data bits
50MHz clock rate for four data bits
• Lockable 512 byte OTP security sector
• Minimum 100K endurance cycle
•
-
• Low power consumption
- 12 mA typical active current
- 1 μA typical power down current
•
-
High performance program/erase speed
Page program time: 1.3ms typical
Sector erase time: 90ms typical
Block erase time 500ms typical
Chip erase time: 25 seconds typical
Uniform Sector Architecture:
1024 sectors of 4-Kbyte
64 blocks of 64-Kbyte
Any sector or block can be erased individually
Package Options
8 pins SOP 200mil body width
8 contact VDFN (5x6mm)
8 contact VDFN (6x8mm)
8 pins PDIP
16 pins SOP 300mil body width
24 balls TFBGA (6x8mm)
All Pb-free packages are RoHS compliant
• Industrial and Extended temperature Range
GENERAL DESCRIPTION
The EN25Q32B is a 32 Megabit (4096K-byte) Serial Flash memory, with advanced write protection
mechanisms. The EN25Q32B supports the standard Serial Peripheral Interface (SPI), and a high
performance Dual output as well as Quad I/O using SPI pins: Serial Clock, Chip Select, Serial DQ0(DI),
DQ1(DO), DQ2(WP#) and DQ3(NC). SPI clock frequencies of up to 80MHz are supported allowing
equivalent clock rates of 160MHz for Dual Output when using the Dual Output Fast Read instructions,
and SPI clock frequencies of up to 50MHz are supported allowing equivalent clock rates of 200MHz for
Quad Output when using the Quad Output Fast Read instructions. The memory can be programmed 1
to 256 bytes at a time, using the Page Program instruction.
The EN25Q32B is designed to allow either single Sector/Block at a time or full chip erase operation. The
EN25Q32B can be configured to protect part of the memory as the software protected mode. The
device can sustain a minimum of 100K program/erase cycles on each sector or block.
This Data Sheet may be revised by subsequent versions
or modifications due to changes in technical specifications.
1
©2013 Eon Silicon Solution, Inc.,
Rev. H, Issue Date: 2013/04/29
www.eonssi.com